Important Guideline for the Split AC Installation
In this article, you will know about the important guidelines for the split AC installation. The installation of the split AC conditioners is such a crucial job.
If the installation is done accurately, your AC will provide optimum cooling. If it is not done properly, you will not get the desired cooling effect.
A poor installation also leads to a frequent maintenance problem.
Here are several factors that are considered during the installation of the split air conditioner.
The Strength of Wall to Hold the AC
The indoor unit of split AC must be installed on a wall strong to hold the AC weight.
Proper Spacing Between the wall and AC unit
The indoor unit of split AC requires an at least 15 cm of open space from the sides for the proper air flow and from the top.
Appropriate Installation Height from the Ground
Mount the indoor unit of split AC at a height of 6-7 feet above the ground which requires adequate cooling inside the room.
The Correct Tilt Angle of the Indoor Unit
When fixing the aluminum bracket on a wall. You make sure that bracket is given to be slight tilt angle.
So that split AC is also fitted at a slight angle. It enables un ran restricted flow of condensed water from the drain pipe.
Correct Location of the Outdoor Unit
For an proper cooling, mount the outdoor and indoor of split AC must away from direct water and sunlight.
Install the outdoor unit of split AC in full open space, so that there is no hindrance when heat is dissipated from the condenser.
Proper placement for an outdoor unit
The outdoor unit of split AC must be placed on a rigid and flat surface. This unit mainly contains key components of split AC are a compressor, fan motor, condenser etc.
If the unit is not a flat surface then it vibrates very excessively. It can also lead to breakage of compressor/condenser damage, coolant leakage, copper wires etc.
Further, the vibrating unit also makes a lot of noise which disturbs you and your neighbor also.
Correct Distance Between the Indoor and Outdoor Unit
In split AC there would be a correct distance between the outdoor and indoor unit. It plays an important role in cooling.
The coolant at low temperature flows inside the copper tubes between the outdoor and indoor units of splits AC. When the refrigerant flows between the units then there is always some loss of cooling effect.
To overcome this loss, the distance between the outdoor unit and indoor unit is minimum as possible. It can be about 15 meters.
Well, this was the end of the article of important guidelines for split AC installation.
Dynamic AC is to provide the best AC installation service. We provide full service and offer complete work of air conditioners to meet every customer needs.